Bonjour,
Avant de démarrer aucun problème - tout parait être normal,
la fonction de la pedale embrayage et son marge, levier des rapports, etc.
Mais, quand le moteur est tournant, même si la voiture est toujours immobile,
on ne peut plus engager un rapport sans des bruits révoltant.
( Le même quant la voiture est roulante ).
Est-ce quelqu'un a un solution de cet problème ??
Merci par avance !
A cause de mon francais mal écrit, ci dessous le même en anglais :
As long as the engine is not started - everything seems normal,
the leeway of the clutch pedal, the gear lever, engaging of gears, etc.
But, as soon as the engine is running, even when the car is not in motion,
you cannot engage gears without considerable force and a screeming noise.
( The same when the car is in motion ).
Does anyone have a solution to this problem ??
Thanks in advance !
Cher passionnés,
Depuis 2019, il est devenu obligatoire de recenser votre 10 Hp auprès de l'amicale pour pouvoir accéder au forum.
Voici quelques mois nous avons demandé aux utilisateurs de ce forum de bien vouloir recenser leur 10hp.
Certains d’entre vous l’ont fait, d’autres non.
Aujourd’hui nous nous apprêtons à modifier les conditions d’accès au forum.
Sans recensement à jour de votre 10 Hp, vous ne pourrez bientôt plus poster de messages, donc plus d’échange possible au sein du forum.
Je vous rappelle que le forum est totalement gratuit !
Vous pouvez le faire ici : Recensez votre véhicule
Cordialement
Le président
Roland
Depuis 2019, il est devenu obligatoire de recenser votre 10 Hp auprès de l'amicale pour pouvoir accéder au forum.
Voici quelques mois nous avons demandé aux utilisateurs de ce forum de bien vouloir recenser leur 10hp.
Certains d’entre vous l’ont fait, d’autres non.
Aujourd’hui nous nous apprêtons à modifier les conditions d’accès au forum.
Sans recensement à jour de votre 10 Hp, vous ne pourrez bientôt plus poster de messages, donc plus d’échange possible au sein du forum.
Je vous rappelle que le forum est totalement gratuit !
Vous pouvez le faire ici : Recensez votre véhicule
Cordialement
Le président
Roland
Problème Bôite B2 1922
Re: Problème Bôite B2 1922
Hi Stephane,
When you action the clutch pedal, it pushes, (using the clutch release connection), against a shaft which rotates 3 arms. These arms pull the cluth plate, which releases the clutch itself, and so unlinks the motor exit of the gearbox.
If one of these 3 arms is broken, or exited from its housing, you feel the same resistance when you action the pedal, but the clutch plate stays pressed in a part of its circumference.
It could be your problem.
And the only way to control that is to back out the gear box. Doing that, you can lift the shaft off and action each arm.
It is neither complicated or long: all can be done within 2 or 3 hours.
Laurent
When you action the clutch pedal, it pushes, (using the clutch release connection), against a shaft which rotates 3 arms. These arms pull the cluth plate, which releases the clutch itself, and so unlinks the motor exit of the gearbox.
If one of these 3 arms is broken, or exited from its housing, you feel the same resistance when you action the pedal, but the clutch plate stays pressed in a part of its circumference.
It could be your problem.
And the only way to control that is to back out the gear box. Doing that, you can lift the shaft off and action each arm.
It is neither complicated or long: all can be done within 2 or 3 hours.
Laurent
Laurent
Re: Problème Bôite B2 1922
Hi Laurent,
Thanks for the explanation !
Just one further question :
Is this "diagnosis" good even for the fact, that the car starts OK in gear as long as the clutch pedal is kept down.
Everything then seems to be normal ( no tendencies of pulling etc ), and the clutch engages distinctly upon the release of the clutch pedal ( around two thirds up from the floor ).
Thanks !
Kind regards,
Stephane
Thanks for the explanation !
Just one further question :
Is this "diagnosis" good even for the fact, that the car starts OK in gear as long as the clutch pedal is kept down.
Everything then seems to be normal ( no tendencies of pulling etc ), and the clutch engages distinctly upon the release of the clutch pedal ( around two thirds up from the floor ).
Thanks !
Kind regards,
Stephane